In den Warenkorb

Klark Teknik SQ1S Splitter

- Inputs 8 (mic/line)
- Typ: Analogue, electronically balanced, female XLRs (Pin 2 hot)
- Maximum input level 22dBu
- Input impedance 5k ohms
- Common mode rejection -80dB at 1kHz (typical), unity gain (0dB)
- ratio (CMRR) -100dB at 1kHz (typical), maximum gain ( 40dB)
- Outputs 16 (rear panel)
- Type Analogue, electronically balanced, male XLRs (Pin 2 hot)
- Operating level 0dB
- Maximum level 22dBu
- Output impedance <50 ohms
- Signal drive capacity <600 ohms

8 Outputs (front panel):

Type Analog, transformer isolated balanced, male XLRs (Pin 2 hot) - Operating level -6dB
- Maximum level 22dBu
- Output impedance <75 ohms
- Signal drive capacity <600 ohms
- Headphone output 1
- Type Analogue, TRS jack socket
- Rating 750mW (nominal 50 ohm load)

Anschlüsse:

Audio Front panel connectors:

Channel input eight x AA series female XLRs (labelled "IN 1" to "IN 8")

Isolated output C eight x AA series male XLRs (labelled "TX OUT 1" to "TX OUT 8")

Headphone output one 1/4" TRS balanced jack socket

Rear panel connectors:

Channel input eight x AA series female XLRs (labelled "IN 1" to "IN 8")

Electronic output A eight x AA series male XLRs (labelled "OUT A")
Electronic output B eight x AA series male XLRs (labelled "OUT B")
- Power: 3-pin IEC

- Frequency response1 ±0.5dB (input to output), 20Hz to 20kHz
- Distortion <0.02% @ 1kHz, 0dBu at unity gain
- Dynamic range2 Electronically balanced outputs: >122dB*
- Transformer isolated outputs: >140dB*
- Noise floor3 Unity gain <-100dBu*
- Mic EIN @ 40dB gain <-128dBu*
- High pass filter: Filter frequency -3dB @ 30Hz, Filter slope 12dB per octave

Power Requirements:

- Voltage 100VAC to 240VAC ±10%
- Frequency 50Hz to 60Hz
- Consumption <35W

Dimensions:

- Height 88 mm (3.5"), 2U high
- Width 482 mm (19")
- Depth 200 mm (7 7/8")

Weight:

- Net 4.5 kg
- Shipping 5.7 kg