Add to cart

Klark Teknik DN 370:

- Analogue Equaliser
- Long-throw 45mm oil-damped faders with dust cover for increased
accuracy and resolution.
- All-new proportional-Q filters provide optimum control without
undesirable audio artifacts.
- Gain control with 6dB/-infinity range and centre detent at unity gain. Allows effective muting of channel in emergencies
- Range switch selects ±6dB or ±12dB operation for the faders, with LED indication
- Channel bypass switch with LED indication - the unit also provides automatic relay bypass in the event of power failure
- Sweepable high-pass filter with 20Hz to 500Hz range - sets the
lower frequency limit of the system. The control incorporates a push switch to select the filter in and out, with an illuminated ring for "at a glance" status indication. Invaluable for smooth rejection of unwanted subsonic and low frequencies, particularly relevant with modern, compact wedge monitors.
- Sweepable low-pass filter with 2kHz to 20kHz range - sets the
upper frequency limit of the system. The control incorporates a push switch to select the filter in and out, with an illuminated ring for "at a glance" status indication. Provides optimum bandwidth control for vocal monitors and IEM systems
- Two sweepable notch filters per channel, with overlapping
frequency ranges of 20Hz to 2kHz and 200Hz to 20kHz. These allow
precise removal of problem frequencies with minimal effect on the rest of the program material, and fast control of "between fader" frequencies. This gives precise control of room and loudspeaker
resonance/feedback nodes with minimum loss of energy - even between ISO centres. The controls each incorporate a push switch to select the filter in and out, with an illuminated ring for "at a glance" status indication.
- Bypass switch with status LEDs for quick comparison of applied EQ
- Power switch, fully recessed in the "on" position to avoid
accidental operation
- Signal present LEDs show the presence of audio signals above
-40dBu
- Multi point clip monitoring. Clip warning LEDs illuminate when the level exceeds 20dBu (2dB below the onset of clipping) to assist in optimum system gain setting
- Electronically balanced inputs and outputs (transformer balancing is available as an option). Connections are provided on both XLRs (pin 2 hot) and Phoenix-type strip connectors for fixed installation
- IEC mains inlet. The unit automatically adjusts for operation on
all voltages from 100 to 240V AC
- KT logo for quality engineering and reliability
- 3-year KT warranty for peace of mind.
- Rugged, roadworthy steel chassis